Zipfit Liners

If you're worried about the size, you can always just get a lower-volume Zipfit and add more cork to get a "high volume" fit later. The primary difference between the liner volumes is the amount of cork that comes with the boot. In theory you can also remove cork, but that's more difficult/messy.

I have a pair of zipfit GFTs with about two extra tubes of cork added.. I use them in my resort shells as well as my low-volume touring shells (hawx ultra 130s) and they are great in both.

Their "volume" thing is kinda counterintuitive because it has nothing to do with the last but rather with the amount of the cork they add by default. ZipFit's "usual" (not racing) liners fit probably every boot (not plug boots tho) since you have stretchy neoprene at the toebox and sticky rubber thing at the calve area that grips onto your shells.

Take their quiz and see what they say

Zip fits aren’t worth it dude especially in your boot.

They last 500 days for $500.

you can get an intuition liner for $100 that will last over 100 days.

on a per dollar basis you’re getting more out of your money by going with the intuition.

Plus you don’t have to put up $500 in a single purchase, you can spread out the cost over several years.

Also zip fits just aren’t a good fit for 3 piece boots. Wrap liners are better for 3 piece. If you were in a traditional boot then yes I’d recommend the zip fit.

**This post was edited on Nov 19th 2024 at 10:54:08pm

I run freeride liners in my Shadow and RS LV with no issues. I think they would be more than fine in that revolver.

Some people here tried it

https://www.skitalk.com/threads/2022-full-tilt-k2-anyone-seen-what-theyll-look-like.25491/page-2

In my experience, it really depends on how the shell fits. If the shell is a "performance fit," you're limited to the Corsa or Sidewinder. I ski the new RS 130 MV with a Corsa. I tried a Gara LV and couldn't even get the cuff to close, so it really depends on the fit of the boot.

Good info in that link. Lots of guys in that thread saying the wrap liner fits better in 3 piece shells. Zip fit doesn’t take up enough volume.

PartyBullshiitSome people here tried it

https://www.skitalk.com/threads/2022-full-tilt-k2-anyone-seen-what-theyll-look-like.25491/page-2