• Forums
  • Gear Talk
  • K2 Revolver Pros (2023 - those white ones) wire disconnection🫠

Member of the Month

GayWolf420
June, 2025

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

K2 Revolver Pros (2023 - those white ones) wire disconnection🫠

profile picture
Mellow.dome
Posts: 2 - Karma: 34
Hello folks, just acquired some brand new Revolver Pros from last season, took my first run and the bottom wire has popped out of its housing. I’ve tried fixing it but the bolt head just spins and spins. Anyone had this issue before?
a year ago
1 2
profile picture
PsychicMigration
Posts: 2099 - Karma: 10,552
Buy full tilts.
a year ago
14 2
profile picture
tdollo
Posts: 3885 - Karma: 19,906
unscrew and remove the black screw and make sure you put the wire-end correctly thru the metal O ring thing, then tighten put it back and tighten it.
a year ago
3 0
profile picture
deac
Posts: 854 - Karma: 4,051
PsychicMigrationBuy full tilts.


no longer funny
a year ago
1 8
profile picture
BallClapper
Posts: 3725 - Karma: 16,891
deke_skino longer funny


Always funny.
a year ago
2 0
profile picture
tomPietrowski
Posts: 7296 - Karma: 18,731
tdollounscrew and remove the black screw and make sure you put the wire-end correctly thru the metal O ring thing, then tighten put it back and tighten it.

This. If the screw is spinning reach inside and feel the star nut in the back. That may have come slightly out of the shell and is just spinning inside. If this is the case, try to push it back in or hold it while you undo the ski. Once out if teh star nut has lost teh four little prongs replace it.

**This post was edited on Jan 30th 2024 at 3:16:29pm
a year ago
2 0
All times are Eastern (-4); Currently it's 5:48AM