Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Sth2 16 adjustment question
Posts: 134
-
Karma: 1,554
So im planning on hopefully getting new boots this summer, stepping into a whole size down (from 29.5 to a 28.5). Ive got last years sth2 16 mounted to my 29.5’s right now. My question is if i get a new size boot will i have to get my bindings remounted to fit the new boot size or it just an easy adjustment i can do myself? Thanks fellas, have a good summer
Posts: 730
-
Karma: 1,115
As long as they were mounted correctly (in the center of the adjustment range) you should be able to go up or down a full size without remounting. Sth2 might even be able to move 2 sizes… if I remember right the Solomon bindings have a bigger range than others.
Posts: 350
-
Karma: 2,864
They’re listed at 28mm adjustability, so +/-14mm from center (assuming bindings are mounted at middle of adjustability like above mentioned). You should be fine, but check BSL of new boots to be sure.
Posts: 3884
-
Karma: 19,898
should be fine. When a boot is set to a jig, the binding tends to be mounted in the middle of the adjustment range
All times are Eastern (-4); Currently it's 4:43PM
