Member of the Month

GayWolf420
June, 2025

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

How to fix this

profile picture
Eli.braun98
Posts: 296 - Karma: 1,845
I attempted to mount my first pair of skis a couple of days ago. I bought these skis for really cheap and mounted them with some old marker squires I found lying around in my garage. After I pre-drilled all the holes and screwed in the final 2 screws on the heel piece I forgot to attach the brake so the screw went in a little too far and now the base is bulging. What are your guy's thoughts on how to fix this? My dad wants to cut off the little bulge and then P-Tex it but IDK if it's worth going through all that trouble






2 years ago
3 1
profile picture
thewayshego3s
Posts: 220 - Karma: 1,786
I’d personally cut and/or sand the bulge down and p Tex it.
2 years ago
4 0
profile picture
tdollo
Posts: 3884 - Karma: 19,898
Pull the screw out and hammer the bulge back as much as you can. Then add a lot of glue and a bit of saw dust to the hole so when you put the screw back in, it sits snug. If you have access to a ski shop i'd get them to base grind the ski afterwards so shes mint.

Ptex fix by sanding it down works too, theres no rulebook for this shit so give it a go and see how she turns out!

Best of luck

**This post was edited on Feb 22nd 2023 at 6:15:13pm
2 years ago
7 0
profile picture
Non_State_Actor
Posts: 5100 - Karma: 18,714
Just scrape it flush with a blade. If there's a hole afterwards just pop a drop of ptex in and cut it flush after the ptex cools.
2 years ago
2 0
profile picture
Tucko
Posts: 228 - Karma: 1,927
tdolloPull the screw out and hammer the bulge back as much as you can. Then add a lot of glue and a bit of saw dust to the hole so when you put the screw back in, it sits snug. If you have access to a ski shop i'd get them to base grind the ski afterwards so shes mint.

Ptex fix by sanding it down works too, theres no rulebook for this shit so give it a go and see how she turns out!

Best of luck

**This post was edited on Feb 22nd 2023 at 6:15:13pm


Add a little bit of heat with a heat gun or hair blower before hammering too
2 years ago
3 0
profile picture
BradFiAusNzCoCa
Posts: 7548 - Karma: 67,093
Heat and hammer. I have same problem with some rock skis and they’re fine
2 years ago
1 0
All times are Eastern (-4); Currently it's 5:46AM