It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Hey, I’m newer to the park skiing scene and recently have a pair of skis mounted with look pivot 14s and currently have a boot with a bsl of 335, and just purchased some full tilts with a bsl of 326, and was wondering if the pivots could be adjusted from 335mm to 326mm without a remount?
i can't remember the answer but this comes up every now and then on here. google site:newschoolers.com + look pivot adjustment (or similar) and i bet you find some good info
Yours would be a 9mm adjustment so no it wouldn’t work
bwork_1Hey, I’m newer to the park skiing scene and recently have a pair of skis mounted with look pivot 14s and currently have a boot with a bsl of 335, and just purchased some full tilts with a bsl of 326, and was wondering if the pivots could be adjusted from 335mm to 326mm without a remount?
**This post was edited on Nov 2nd 2022 at 2:01:06pm
bwork_1Hey, I’m newer to the park skiing scene and recently have a pair of skis mounted with look pivot 14s and currently have a boot with a bsl of 335, and just purchased some full tilts with a bsl of 326, and was wondering if the pivots could be adjusted from 335mm to 326mm without a remount?
Its possible it could work but will depend where in the range the bindings were mounted. If the forward pressure adjustment arms were all the way back it would work. Can you post a pic of one of the arms (the bars the run along the heel and have a screw at the top)?
I’ve squeezed into my friends pivots that were mounted for his 29.5 boot with my 27.5 boot. Clicking in you would need to squeeze against the toe piece then back up slightly to engage the heel piece. Very sketchy experience 10/10 recommend.
Yours would be a 9mm adjustment so no it wouldn’t work
**This post was edited on Nov 2nd 2022 at 2:01:06pm
You really taking advice from a guy who’s profile pic is a quiver of tyrolias?
OP Im not totally sure but I think look claims +/- 10mm if mounted in the center of the range. It seems a little smaller than that imo but you really wont be sure if theyll fit until you try
The pivot jig when adjusted correctly with boot, should have the forward pressure (the tightening of the arms) about half screwed in; effectively on the second marking (circled in blue).
It's probably gonna not gonna work my g.
I’m looking at my pivots now. Pretty sure is 10mm total aka a centimeter
Paul.You really taking advice from a guy who’s profile pic is a quiver of tyrolias?
OP Im not totally sure but I think look claims +/- 10mm if mounted in the center of the range. It seems a little smaller than that imo but you really wont be sure if theyll fit until you try
