Member of the Month

GayWolf420
June, 2025

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Look Pivot 18

profile picture
Halbo
Posts: 0 - Karma: 13
Anybody out there have any clue on the toe piece screws for Look Pivot 18 gw as apposed to non gw plates? I’m swapping out a pair and would like to use the same screws per hole with of course a little Roo glue in each. I’m sure once I yank them it will be pretty obvious.
3 years ago
2 0
profile picture
rojo.grande
Posts: 1560 - Karma: 12,730
I could be wrong but I think the two inner screws towards the middle of ur sole on the gw afd are longer than the standard alpine afd screws, but maybe im crazy. Id just hit your shop and see if they have an extra set around that u can nab for a few bucks
3 years ago
2 0
profile picture
elm.
Posts: 1510 - Karma: 13,606
When I replaced my alpine for non gripwalk I took out the spring and the gripwalk afd was attached to a post. This was for cast I think it's the same for regular
3 years ago
0 0
profile picture
CSteaZy
Posts: 51 - Karma: 239
They use different screws because of the different AFDs. Probably should try and contact Look directly, or go to your local shop and see if they can help you out.
3 years ago
0 0
profile picture
tdollo
Posts: 3885 - Karma: 19,904
They use the same ones because you just swap the AFD plate. Undo the screws by hand to make sure not to strip, swap the afd plate, put glue in da holes, screw that shit back in.


3 years ago
1 0
All times are Eastern (-4); Currently it's 1:59PM