I did an at home mount once and I got really into it and spent a lot of time. Had a few fuck ups but got it right in the end. Ultimately, my downfall was I measured center mount differently on the two skis. So it was a success but a stupid, human error.
Regardless, it’s made me really start observing mount jobs and yes. I have noticed that shops can be sloppy with the jig and the bindings can be off center. Also, shops can be sloppy with fully sealing holes and making sure screws are fully in/base plates are flush
ajbskiedit 2: ive also seen shops with actual jigs screw up mounts worse than this.
**This post was edited on Feb 3rd 2022 at 3:13:57pm
**This post was edited on Feb 3rd 2022 at 3:16:11pm