Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Change bindings same position?
Posts: 3
-
Karma: 51
Looking into upgrading into some pivot 15's from my griffon id 13's but want to keep them true center is there any way I can do so even though the holes for the griffons are already drilled?
Posts: 2213
-
Karma: 16,945
you should be good the existing screw holes from the griffons shouldn't line up to pivots...personally had to remount my sticks that had fks on em with some attacks and had no issues clearing the previous 2 mounts.
Posts: 3733
-
Karma: 17,761
The only trouble might be the holes for the toes if you're mounting to the same BSL. If anything, I'd go -1cm from true center. You won't notice a difference and new holes can properly be drilled.
All times are Eastern (-4)