Member of the Month

BradFiAusNzCoCa
October, 2022

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Custom jig

profile picture
piss_boy
Posts: 1109 - Karma: 7,140
My dad has a cnc machine and is gonna cut a plate with holes for attacks in it. Ns have any ideas for how to fasten it to the ski and allign it?
Oct 17 2021 5:08PM 6 0
profile picture
pbs
Posts: 460 - Karma: 3,124
I think marking then visually lining up on boot center and ski center, clamp the jig and drill to the moon.
Oct 17 2021 6:13PM 1 0
profile picture
piss_boy
Posts: 1109 - Karma: 7,140
pbsI think marking then visually lining up on boot center and ski center, clamp the jig and drill to the moon.

Allright. Gonna feel so sketchy doing that myself but better then a shop
Oct 17 2021 6:14PM 1 0
profile picture
BLandz
Posts: 915 - Karma: 13,952
If ur dad owns a CNC machine than he has enough money to pay for new skis if you fuck it up just go ham
Oct 18 2021 9:09AM 14 0
profile picture
animator
Posts: 4177 - Karma: 22,721
BLandzIf ur dad owns a CNC machine than he has enough money to pay for new skis if you fuck it up just go ham


LOL
Oct 18 2021 11:25AM 3 0
profile picture
elm.
Posts: 1368 - Karma: 12,451
Here's one I tried last season. Maybe it'll give you inspiration.

https://www.newschoolers.com/forum/thread/920443/3D-Printed-ski-Jig]3D Printed ski Jig https://www.newschoolers.com/forum/thread/920443/3D-Printed-ski-Jig[/url]

To center them, I'd just put a notch at the center of the top and bottom of the jig then line it up with the vertical center of the skis. Clamping just use quick clamps/c clamps. Keep it as simple as possible.

Look into using 80/20 extruded aluminum for the rails if you go that route.
Oct 18 2021 8:10PM 1 0
profile picture
S.Ki
Posts: 2142 - Karma: 2,948
check this out

https://www.thingiverse.com/thing:4641270/makes
Oct 19 2021 4:13PM 0 0
profile picture
abar.
Posts: 1060 - Karma: 6,825
Just make sure you measure the crap out of the holes before you drill, mark them using the jig you make and make sure they're all in the right spot and square before you drill
Oct 21 2021 8:07PM 0 0
All times are Eastern (-5)