Look pivot mounting

If ur selling ur skis just bring them to a shop to unmount them so they can plug the existing holes

You can literally just unscrew the bindings straight off the ski. Doesn’t need to go to a shop. Just keep the skis dry. The next owner will have the holes plugged when the skis are mounted.

you can also get a pack of plugs for about a nickel. a little wood glue and a hammer and you are all set. just cut off the top of the plug if there is any sticking out about the topsheet

just make sure that any future binding mounts are a few mm away to avoid drilling into an especially weak section of the ski due to the preexisting holes

**This post was edited on Aug 9th 2021 at 3:47:24pm

bennwithtwonsyou can also get a pack of plugs for about a nickel. a little wood glue and a hammer and you are all set. just cut off the top of the plug if there is any sticking out about the topsheet

just make sure that any future binding mounts are a few mm away to avoid drilling into an especially weak section of the ski due to the preexisting holes

**This post was edited on Aug 9th 2021 at 3:47:24pm

This is good advice to re-mount skis, but for selling them don't sweat it, strip the bindings off and sell them as is. The future buyer can decide to plug the holes or potentially re-use them.