Member of the Month

ReturnToMonkey
March, 2021

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Removing Bindings

profile picture
Carter_Meyer
Posts: 17 - Karma: 116
This probably sounds stupid but do shops use glue or epoxy when mounting bindings? Im trying to take my pivots off and the screws won’t budge and I don’t want to strip them out. If they were glued/epoxied, how would I go about removing the bindings so I can sell the skis?
Mar 30 2021 1:31PM 6 0
profile picture
Session
Posts: 4258 - Karma: 8,439
Try heating the screw up. If you have a soldering iron just touch it to the screw for a little bit.
Mar 30 2021 1:37PM 3 0
profile picture
OregonDead
Posts: 6037 - Karma: 14,175
no there shouldn't be any epoxy or anything holding them in. just make sure you use the correct driver #3 pozi drive
Mar 30 2021 1:38PM 5 0
profile picture
jjdsteeze
Posts: 2474 - Karma: 3,480
are you just using a phillips head? that is probably your issue
Mar 30 2021 2:48PM 1 0
profile picture
zeke.oblique
Posts: 163 - Karma: 493
Carter_MeyerThis probably sounds stupid but do shops use glue or epoxy when mounting bindings? Im trying to take my pivots off and the screws won’t budge and I don’t want to strip them out. If they were glued/epoxied, how would I go about removing the bindings so I can sell the skis?


Shops always use wood glue when they screw in the binding screws, no epoxy tho
Mar 30 2021 4:32PM 4 0
profile picture
MaimHelp
Posts: 659 - Karma: 2,865
Get a pozidriv #3 or you can use a big ass philips head. Push hard down on the screw and slowly loosen it. Once it initially breaks lose they are easy to take out
Mar 30 2021 9:13PM 2 1
profile picture
tdollo
Posts: 2838 - Karma: 6,175
shops will use epoxy for helicoils or if they've stripped a screw while mounting.
Mar 30 2021 10:07PM 5 0
profile picture
anders_a
Posts: 1292 - Karma: 3,801
yeah, shop did somthing bad, they just gonna stick a helicoil or similar at best, or just epoxy at worst in there.
Mar 31 2021 1:36PM 0 0
profile picture
No.Quarter
Posts: 4591 - Karma: 9,589
OregonDeadjust make sure you use the correct driver #3 pozi drive


This is very important. It can be difficult to find a dedicated #3 pozi screwdrivers at most general hardware stores but much less difficult to find just a p#3 bit that you can use with 1/4 hex screwdriver
Mar 31 2021 3:14PM 4 0
profile picture
BradFiAusNzCoCa
Posts: 1187 - Karma: 6,561
Bought my pozidriv #3 at an auto store. Pretty cheap on Amazon too
Apr 1 2021 3:01PM 1 0
All times are Eastern (-4)