It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Had to make some adjustments to my Full Tilt FC10. Changed the cant insert and now the plate won’t go back together correctly. I took the entire cuff apart to see if there was anything else going on but there wasn’t. The right boot went together correctly but the left won’t.
Right boot
Left boot. Plate sits on raised part of upper cuff.
CatdickBojanglesHad to make some adjustments to my Full Tilt FC10. Changed the cant insert and now the plate won’t go back together correctly. I took the entire cuff apart to see if there was anything else going on but there wasn’t. The right boot went together correctly but the left won’t.
Right boot
Left boot. Plate sits on raised part of upper cuff.
This happened to me when I dyed mine. I had to try 5 or 6 different times, I found that taking the forward lean wedge out when putting it back together helped, once I had the cant plates on correctly I just shoved the wedge back I.
animatorThis happened to me when I dyed mine. I had to try 5 or 6 different times, I found that taking the forward lean wedge out when putting it back together helped, once I had the cant plates on correctly I just shoved the wedge back I.
Would it have to do anything with the other side of the boot? Still not sure what the other side does.
tomPietrowskiLooks like teh black part is not fully seated correctly, is it flush to the cuff?
Yeah it just looks like that because there’s a little bit of plastic left over from manufacturing. But that’s the boot that goes back together correct.
tomPietrowskiOh sorry yeah see that now. So the one you cant get together, if you take the screw out of the cap and place it in the cuff do the holes line up?
So did that part fit before? Obviously its position in the cuff is not changing. You are only changing the position of the cuff on the lower shell so adjusting it should in no way change where that part sits in the cuff
tomPietrowskiSo did that part fit before? Obviously its position in the cuff is not changing. You are only changing the position of the cuff on the lower shell so adjusting it should in no way change where that part sits in the cuff
Yes it fit before I just changed the cant insert from whatever comes in them stock to the 3 and now it doesn’t. Not sure what is causing it to not go
back together right because the other one does just fine.
**This post was edited on Feb 9th 2021 at 7:56:58pm
tomPietrowskiSo did that part fit before? Obviously its position in the cuff is not changing. You are only changing the position of the cuff on the lower shell so adjusting it should in no way change where that part sits in the cuff
So I took it apart and looked and with the #3 cant insert in and the upper cuff apart it is impossible to get the cant plate to line up in the middle of the hole to go back together properly. Not sure why it does on one boot and not the other.