Member of the Month

profa_212
July, 2025

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Roxa r3 gripwalk and attack 13s pre release problem

profile picture
BowfinBaron
Posts: 9 - Karma: 36
So my bindings have been pre releaseing in the toe offten. I think the problem is that the ADF plate is not touching the orange plate on the bottom of my boots, it's just hitting the rubber part of the grip walk sole. When I go to lower the toe piece so it's not touching the rubber it is then to loose! And there is a large gap between the ADF and the boot. Are attack 13s not grip walk compatible?






5 years ago
1 0
profile picture
CatdickBojangles
Posts: 6496 - Karma: 66,610
Are they Attack2s? Also I'm not positive but don't you manually adjust the attacks?
5 years ago
1 0
profile picture
animator
Posts: 4576 - Karma: 26,432
CatdickBojanglesAre they Attack2s? Also I'm not positive but don't you manually adjust the attacks?


yes, the AFD needs to be manually adjusted.

OP, you need to ideally have a gap pf 0.5-1.0mm between boot sole and AFD. Adjust by pulling the boot back when its clicked in (sort of like as if you were leaning back while clicked in to your skis), and then adjust AFD and then let go of boot. I use a business card to test, you should be able to put a business card in the gap and pull it out. It should not just glide in and out, there should be resistance but it should also not rip or tear the card. If this doest work, check your forward pressure
5 years ago
2 0
profile picture
tomPietrowski
Posts: 7296 - Karma: 18,734
How old are those bindings?
5 years ago
0 0
profile picture
animator
Posts: 4576 - Karma: 26,432
Oh that’s a fair point, only the Attack 2 and above will work w grip walk. If you have the OG attacks they’re not gonna work
5 years ago
0 0
profile picture
freeskibum82
Posts: 6355 - Karma: 5,056
That looks like the older 13 without GW compatibility. The AFD on the GW version is designed completely differently i believe.
5 years ago
2 0
All times are Eastern (-4); Currently it's 1:38AM