It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
yikes boys
also may i add that this all happened in literally 1 ski day. im guessing it peeling off a tiny bit, A LOT of moisture got in and now my topsheet is fucked. Epoxy?
I dont follow atomic skis all that much so I have no clue what ski that is or what year. But if its a relatively new ski I'm sure they would warranty that?
BigTexasI dont follow atomic skis all that much so I have no clue what ski that is or what year. But if its a relatively new ski I'm sure they would warranty that?
unfortunately they are too old for warranty. them babes all i got so i have to fix em
yikes boys
also may i add that this all happened in literally 1 ski day. im guessing it peeling off a tiny bit, A LOT of moisture got in and now my topsheet is fucked. Epoxy?
It's just a thin sheet of plastic for the graphics. Just cut it off. Then ski!
I have some QST's that did that after they got ran over twice but cars!
Skis are fine!
I’d also go this route, cut the graphic off and let her rip
DominatorJacquesIt's just a thin sheet of plastic for the graphics. Just cut it off. Then ski!
I have some QST's that did that after they got ran over twice but cars!
Skis are fine!
You can try to use a spray or roll on glue to glue it back down. Use a small foam paint roller or vinyl wrap squeegee to press the top sheet down onto the glue and get rid of excess glue (press from the center to the edge).
Have damp paper towels to wipe excess.
Another idea is to peel up the top sheet and put down a vinyl wrap where the top sheet was.
I would also cut/tear it off. This happened to my older JJ's, and a lot of other older armadas. Chances are if u spend money/time on epoxy it will just start coming off in another spot that u will have to fix again.
Just make sure you epoxy/JB Weld any serious dings your get after ripping off top sheet.