It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
How do you adjust it on Full Tilts? Here is what the instructions say but i cant get the disk to go back in other than the stock position. And what positions equal what angle? Any info would be much appreciated.
What part are you struggling with? You change the piece with either the center hole or the offset whole to adjust the cuff. The outer disc will appear in the same place but offset the cuff to the clog.
tomPietrowskiWhat part are you struggling with? You change the piece with either the center hole or the offset whole to adjust the cuff. The outer disc will appear in the same place but offset the cuff to the clog.
Got it so up (or down) is in the picture above middle the line would be parallel with the ground and down would be the front line (pointed kind of up in the pic) would be pointed down?
It’s to do with the black plastic piece with the circle in it. If the circle is in the middle that is neutral. If the circle is at the top that pulls the cuff outward. If the circle is at the bottom it pushes it inwards.
tomPietrowskiIt’s to do with the black plastic piece with the circle in it. If the circle is in the middle that is neutral. If the circle is at the top that pulls the cuff outward. If the circle is at the bottom it pushes it inwards.
Gotcha we’re talking about a different piece. I’ve got that piece figured out. I’m talking about the opposite side of the boot. When you remove the cap there are like small teeth in there and small teeth on the cap. Does that do anything at all?
So it has no adjuster in it just a single hole for the screw? Which boot is it?
CatdickBojanglesGotcha we’re talking about a different piece. I’ve got that piece figured out. I’m talking about the opposite side of the boot. When you remove the cap there are like small teeth in there and small teeth on the cap. Does that do anything at all?
@tomPietrowski the parts kit for it is called the outside cuff assembly. What does it adjust? If anything? Here is the pic of the parts kit for it. It might be kind of hard to see.
Then the other side of the boot is the "canting system" which has the 3 different sized plastic inserts that adjust cuff height. It looks like this
Yeah sorry I did not have a boot in front of me and I’m still new to full tilt but yeah you can only adjust it from one side on that boot.
CatdickBojangles@tomPietrowski the parts kit for it is called the outside cuff assembly. What does it adjust? If anything? Here is the pic of the parts kit for it. It might be kind of hard to see.
Then the other side of the boot is the "canting system" which has the 3 different sized plastic inserts that adjust cuff height. It looks like this
tomPietrowskiYeah sorry I did not have a boot in front of me and I’m still new to full tilt but yeah you can only adjust it from one side on that boot.
Ok so the other side does nothing then? Doesn't matter what position it is in. Always appreciate the help!