Member of the Month

profa_212
July, 2025

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

How to bend a ski brake back

profile picture
The.Fish
Posts: 2269 - Karma: 4,999
My friend had an ejection while landing switch and he bent a brake arm pretty bad. What is the most common way to bend it back because it seems to be a common issue on this site. We have tried some stuff but its unsuccessful


**This thread was edited on Dec 5th 2017 at 7:05:14pm
8 years ago
2 0
profile picture
Rum_Ham
Posts: 1449 - Karma: 4,483
I would heat it up where it bent with a small torch and put a pipe on the end and try to bend it back. If that doesn't work a lot of shops have extra brakes and they'd probably just give you one.
8 years ago
1 0
profile picture
sambuswell
Posts: 742 - Karma: 3,462
Saho3914I would heat it up where it bent with a small torch and put a pipe on the end and try to bend it back. If that doesn't work a lot of shops have extra brakes and they'd probably just give you one.

By heating it you are probably going to break the brake arm off. If you have a vice, the best way to bend them is to take the plastic piece off and clamp the brake down really hard and then bend it back by using a pipe or whatever you have for leverage.
8 years ago
2 1
profile picture
Greg_K
Posts: 963 - Karma: 2,791
Agree that the key is to use a metal pipe for leverage with the plastic area in a vice. I use a 6" long 1.25" thicker walled metal plumbing pipe inserted over the brake and it works great even without heat.
8 years ago
1 0
profile picture
Rum_Ham
Posts: 1449 - Karma: 4,483
sambuswellBy heating it you are probably going to break the brake arm off. If you have a vice, the best way to bend them is to take the plastic piece off and clamp the brake down really hard and then bend it back by using a pipe or whatever you have for leverage.


It doesn't need to be glowing red, just a little heat will help a lot.
8 years ago
1 2
profile picture
Non_State_Actor
Posts: 5112 - Karma: 18,806
A couple pairs of visegrips should be able to get it close to it's original shape. They're not that strong really.
8 years ago
1 0
All times are Eastern (-4); Currently it's 8:55PM