Member of the Month

patagonialuke
June, 2020

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Rusty pipe

profile picture
JoeyDill
Posts: 98
I have some rusty 2 inch pipes and I'm thinking of using them for rails for my summer set up.What do i do to them to make them slide able? Do I paint them sand them or just hit them until it smooth ens out.Any tips on what to do please help.
Oct 15 2014 9:30PM
profile picture
Blurst
Posts: 13576
Dip them into a vat of blended hot dogs, you will be sliding with blursting speed in no time!
Oct 15 2014 9:32PM
profile picture
.Dad
Posts: 11879
throw some wax on er' and you should be good to go!
Oct 15 2014 9:38PM
profile picture
T.L.
Posts: 4208
If you have access to an angle grinder go get yourself a wire wheel from home depot.

If you're super broke or don't have an angle grinder, a stack of 3M pads will work pretty well as long as the rust isn't scaling and flaking off.
Oct 15 2014 10:22PM
profile picture
brett_fisher
Posts: 2405
1.paint
2.wax

if its on you're summer setup make the rail wet .
Oct 16 2014 12:22AM
profile picture
brend
Posts: 779
The referenced post has been removed.


Ban hammer.
Oct 16 2014 12:22AM
profile picture
crotchvent
Posts: 1527
brett_fisher1.paint
2.wax

if its on you're summer setup make the rail wet .

Should sand it first. Just one question for you. How do you put a space in between the end of your sentence and the period?
Oct 16 2014 1:40AM
profile picture
theabortionator
Posts: 44740
T.L.If you have access to an angle grinder go get yourself a wire wheel from home depot.

If you're super broke or don't have an angle grinder, a stack of 3M pads will work pretty well as long as the rust isn't scaling and flaking off.


This. You can get a grinder as cheap as 15 bucks at harbor frieght. Dont run too big of a wire brush or youll fry your grinder from the weight.

Who doesnt love a nice clean slick rail. If you glt a grinder you can hit the top with a flap disk as well. Get that shit nice and shiny. Chuck some sprag paint on it. Will come off easy where youre grindong but protect the rest.
Oct 16 2014 2:41AM
All times are Eastern (-4)