Member of the Month

JalmarKalmar
April, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Taking bindings off?

profile picture
.nasty
Posts: 10581 - Karma: 11,098
anyone experienced with taking marker griffons off? don't want to pull anything stupid
Jun 6 2011 4:55PM
0 0
profile picture
I_Am_Mod
Posts: 13214 - Karma: 3,753
#3 pozidrive is all you need, apply good downward pressure so you don't slip and damage the heads...
Jun 6 2011 4:57PM
0 0
profile picture
Sklar
Posts: 8863 - Karma: 31,577
#3 posidrive screw driver, and be carful not to strip the screws

or, is there something special about griffons?
Jun 6 2011 4:57PM
0 0
profile picture
I_Am_Mod
Posts: 13214 - Karma: 3,753
oh and i think the toepiece is loosened with the two screws you can see right in front of the slider plate, remove those and you can slide it back and out, then remove the two screws holding down the front black plastic plate

then heelpiece, screw it all the way back out of the rail
then you should be able to see all (4?) screws that hold down the mounting rail, unscrew those and you're done!

someone verify this ? i don't have my skis right here so i cant check, just remembering from when i had them mounted....
Jun 6 2011 5:04PM
0 0
profile picture
phreshpow
Posts: 834 - Karma: 133
as previous posers said...#3 posidrive
A few kinda special things, there are only 2 screws showing on the toe (the 2 back ones) take those out, slide the toe piece back and off and then remove the two screws that screw in the little black slide in piece that is left.
To take the heel off, keep turning the forward pressure screw to the right right (little one that unscrews while screwdriver is parallel to ski, below the heel post piece) until the heel piece comes out of the track, it will slide forward. then unscrew the 4 screws that hold down the heel plate.
i believe that is all
GOOD LUCK, it isn't too bad
Jun 6 2011 5:05PM
0 0
profile picture
phreshpow
Posts: 834 - Karma: 133
*posters, not posers...my bad
Jun 6 2011 5:07PM
0 0
profile picture
RudyGarmisch
Posts: 25443 - Karma: 13,844
Tape or fill the mount holes to keep water out of the old skis.
Jun 6 2011 5:25PM
0 0
profile picture
Midwestoverdose
Posts: 833 - Karma: 45
I have griffon schizios, im guessing unmounting them would be the same. But just put a lot of pressure with a screwdriver and it should and then try sliding the toe and heel piece away. You have to take the brake of too.
Jun 6 2011 6:41PM
0 0
profile picture
LC.
Posts: 5952 - Karma: 2,423
The heel comes off the track to the front, not the back.
Jun 6 2011 8:16PM
0 0
profile picture
.nasty
Posts: 10581 - Karma: 11,098
thanks guys, went smoothly.
Jun 6 2011 9:15PM
0 0
All times are Eastern (-4)