Member of the Month

GayWolf420
June, 2025

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Help needed with ski edges

profile picture
alexg1687
Posts: 1505 - Karma: 1,582
So i have Ar6s..love them. But some of the edge has burred from rails. ie. The edge has worn down a bit and essentially extended outside its previous widest point. imagine an inverted "T" with the vertical part of that "T" being the ski edge and one side of the 'crossbar' of it being the proper edge. the other side of it is the burred edge. sorry for the complicated explanation but i want to get this right.

so should i file that burr off the edge? i never detuned the edge under the boot. if i should do that, how much should i take off?
14 years ago
0 0
profile picture
meerkat
Posts: 225 - Karma: 524
ya man just take a file and take off the burr i do it all the time
14 years ago
0 0
profile picture
Evilchris
Posts: 2090 - Karma: 44
yep, just use a gummy stone though, it's nicer to your edges
14 years ago
0 0
profile picture
alexg1687
Posts: 1505 - Karma: 1,582
if i take the burr off with it just generate again, thereby losing more of the edge? am i putting myself into a vicious cycle by filing it off, or is it worth it for the sake of control?
14 years ago
0 0
profile picture
Yinzer
Posts: 1011 - Karma: 73
Take it off, your gonna be losing that edge material anyway, use a file to knock the bur off then clean it up with a gummy stone.
14 years ago
0 0
All times are Eastern (-4); Currently it's 4:22PM