It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Iv got a pair of line invaders, they have been mounted once. I manged to pull the binding heel screws out of one of skis. The bindings were Marker M.11 (not very good)
I did it when i crashed on a jump, the brake snapped and the brake pad was all bent and mangled on the binding too. When i did this i was half way down the park so i skied down to the parking lot on it and it skied fine and i didnt notice anything.
I went to my local shop to get a new brake and they told me that the binding was was bent and the screw holes had been threaded so it was either new bindings and a remount or new skis/bindings.
Iv taken the binding off and the screws were threaded, but thats the only damage, the holes are not ripped or mangled
Is it possible to remount in the same holes or remount +1cm/-1cm even though i know its a symmetrical ski and center mount only?
