Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
problem with skis and blown out edges
Posts: 4081
-
Karma: 1,640
ok heres the deal, a couple days ago i was attempting to disaster the bhs rail...with very little luck after an hour of attempts i come out of the night with pieces of edges missing on both of my skis right under the boot on the right hand side and also one of my bindings are broke...so whats the solution here...should i just buy a whole new setup and leave this setup as rock skis, attempt to get warrenty on this, or get the edge repair thing where the guy fills in the missing edges and then try to get my bindings fixed either through warrenty or actually taking it into the shop and fixing it
so fuck you too
sub honcho of ECVM
Posts: 5024
-
Karma: 221
the realquestion is that brookfield high schoolin ottawa? or another bhs?
What the hell were they doing with a car on the moon?... havent they gone far enough?
Posts: 2443
-
Karma: 13
that happend to me on my lines, i got warrenty. now i got new PEs and new Lines, its a hard decision which one to use tommorow... i think im goin with PEs
~Tom
Posts: 6561
-
Karma: 1,375
well since edge work is like 20 dollars an hour and they get like an inch of edge done every hour, then it will have to be rebased. it will probably only cost 150-200 dollars to fix them, but then the edge they put in is always weaker than the rest of the ski.
-jon, skiing the ice so the other half of the country doesnt have to.
-head honcho of ecvm
Posts: 133
-
Karma: 10
depends on the ski company... but generally they will not replace for rails because it is not what a ski is made to do... they will say it is your fault
Fuck you...the first thing i said to niel Turner after i broke my collarbone... and he said i couldnt get hurt
Posts: 48
-
Karma: 10
I had the same problem with my 1080's i am on my 3rd pair already and the edges eventually crack then blow out,I have a decent hookup with salomon and got them replaced for free, but they said they weren't going to replace em for free, u guys think that the pow air grinds are worth it???
Posts: 549
-
Karma: 10
ive never blown my edges out how hard is it to do... and whats a good sign that ur edges are about to bust...is their anyway to lenghten the life of ur edges, like grounding down or what?
Posts: 133
-
Karma: 10
skis are made to go 500 000 meters on snow and only 5000 on a rail
Fuck you...the first thing i said to niel Turner after i broke my collarbone... and he said i couldnt get hurt
Posts: 4081
-
Karma: 1,640
their dynastars in case i didnt mention it...i dont know the other option is to buy a whole new set up that would run me about 330...same exact setup...but i also want to save up for summer camp this summer...and doing anything too expensive would kinda hold me back with my funds
so fuck you too
sub honcho of ECVM
All times are Eastern (-4); Currently it's 9:53PM
