I’ve been trying to find out what the best stuff to use for bindings and tramp skis and nothing holds when you land wrong or tweak it. I’ve just slapped some stuff on a foam sled with plastic on the bottom cut in half. I’m just looking for something that will last more than a few hours of use.
Use tape or some plastic, I wouldn't use anything hard/ solid in case you land wrong and break your ankle or rip the trampoline
little_1337Use tape or some plastic, I wouldn't use anything hard/ solid in case you land wrong and break your ankle or rip the trampoline
What i’ve found best to work is a few long strips of cloth and to wrap them around the bottom of the ski to around the ankles and then wrap them again crossing them over the leg and then tying them off. That usually lasts around a half hour until i have to retire them.
little_1337Use tape or some plastic, I wouldn't use anything hard/ solid in case you land wrong and break your ankle or rip the trampoline
the tape hasn’t worked for me that well, it’s just annoying to use and doesn’t hold the foot from sliding around thanks tough.
Tape and yardsticks works pretty good. You can grab but dont have the absurd weight. Anything heavy isn't really your friend on the tramp
Bushdid9_11spend $300 on skiaddiction tramp skis
BAN THIS SICK FILTH
Take an old pair of sneakers and tape down the heel and above your toes. I have this on some I had lying around and this had held up pretty for me.
Bushdid9_11spend $300 on skiaddiction tramp skis
yeah here’s the link for everyone else http://www.shitaddictionsucksass.com
**This post was edited on Mar 22nd 2020 at 10:56:10am
Take a pool noodle cut it in half and duct tape them on your foot or shoe
WsmyersTake a pool noodle cut it in half and duct tape them on your foot or shoe
last time i did that i rolled my ankle pretty bad a few times. if there was a way to keep it flat that would be great
UtahSuckslast time i did that i rolled my ankle pretty bad a few times. if there was a way to keep it flat that would be great
I flattened them by putting heavy stuff in them while they are flat I would imagine you could put something in the circle too.
SavageBiff
I used my old plastic snowbosrd for the mid 90s for this. Shit worked awesome. Lightweight and had slip in bindings. These are prolly super light too.