Look pivots to marker jesters

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Look pivots to marker jesters

thewaterboy_

Posts: 65 - Karma: 31

Dec 13 2015 10:55PM

So I bought I pair of surface new life's and they've been drilled once already for a p18. Is there a way to mount a marker jester without redrilling? will I have some concerns with the screw pattern on the toe and heel? Thanks guys give me some suggestions.

0 0

japanada

Posts: 13784 - Karma: 1,957

Dec 13 2015 11:27PM

Im pretty sure that none of the holes will line up since the jester/griffon is based off a wider mount pattern than the FKS. You should be able to remount in the same position without any problem. Worst case scenario is that you would have to move the mount +/- 1cm.

0 0

shin-bang

Posts: 4100 - Karma: 6,997

Dec 13 2015 11:49PM

same thing happened to me except the skis were drilled for the markers. my looks then had to be mounted -1 from where i wanted, but i love the way they ride.

0 0

rozboon

Posts: 1642 - Karma: 868

Dec 14 2015 3:44PM

I went the other way, Jesters to FKS.

You can mount in exactly the same spot, assuming the mount pattern hasn't changed.

2 of the toe holes line up.

The other 2 have to be redrilled and are borderline close to the Jester holes but held up fine for me. The FKS mount is actually wider than the Jester.

The heels are 100% different, miles apart, no problems there.

This is all assuming you're going to mount for a boot with a very similar BSL to the one that was on there.

0 0