Condition:
Edges: A lot of rust and needs a good sharpening. No cracks or missing edge.
Base: Minor scrapes and a couple little nicks, nothing close to the core. Could use some wax.
Topsheet: Normal chipping a few deeper dents nothing too bad. A little epoxy was used near the tip but didnt really need it (preventative).
Holes: Here is the issue with these... They were drilled twice (first set was there when I got them). Once for either a tele binding or something like dukes and recently for STH bindings 335 BSL. Toes reused two holes (six total toe holes on each ski). Two holes in the middle of the toe and heel of each. The heels have a plugged set (4 holes like a normal binding and 3 holes that run up the middle of those) Then the STH heel holes. The kicker, the heels are a few mils shifted to one side. I didnt notice it until I took the binding off, but that shop claims they are good (I can read a caliper though and they are slightly off). There is definitely room for another mount if you dont mind a lot of holes. but probably not on the line. You can reuse the STH holes if you dont mind the slight offset.
If these have no value, I will just throw some plates on them and keep them. But, I think these have a lot of life in them, just have a swiss cheese issue.
Offer up if you want them.
