Member of the Month

JalmarKalmar
April, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

PVC like sandpaper

profile picture
steezyjibber
Posts: 15967 - Karma: 11,016
after using my pvc rail for about a month, the top is like sandpaper. any tips for getting it to slide rail again (without turning the pvc?)
Jan 20 2007 9:58AM
0 0
profile picture
fnstoked
Posts: 802 - Karma: 27
Sand it down with... sandpaper!
it should work
Jan 20 2007 10:07AM
0 0
profile picture
steezyjibber
Posts: 15967 - Karma: 11,016
what?????? how?
Jan 20 2007 10:34AM
0 0
profile picture
steezyjibber
Posts: 15967 - Karma: 11,016
bump
Jan 21 2007 10:55AM
0 0
profile picture
J-Flow
Posts: 675 - Karma: 10
sanding it makes it smooth. So use sandpaper and sand the entire surface you are hitting.
Jan 21 2007 1:53PM
0 0
profile picture
Goobie
Posts: 615 - Karma: 30
fine grit sandpaper to make it nice and smoothe
Jan 21 2007 4:52PM
0 0
profile picture
fillup
Posts: 4904 - Karma: 568
wax
Jan 21 2007 7:59PM
0 0
profile picture
Sideways_Shane
Posts: 756 - Karma: 73
sand it
Feb 13 2007 8:43PM
0 0
profile picture
PatVigorito
Posts: 405 - Karma: 12
i think wax makes it slower, just sand the top like everyone else was sayin
Feb 19 2007 9:15AM
0 0
profile picture
bobtheskier05
Posts: 485 - Karma: 20
thank you someone knows the right answer... good job
Feb 19 2007 6:55PM
0 0
profile picture
KrazyistKarl
Posts: 1725 - Karma: 599
sand it down then use a sodering torch and beat it up a bit.
Feb 20 2007 12:00AM
0 0
All times are Eastern (-4)