It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
The edge is intact, looks still attached to the base, but has lifted/delaminated a section from the topsheet. Top sheet is intact. My thoughts were to make a few well placed cuts with a razor along the lifted edge and base and use a flathead screwdriver to lever the edge back into place, epoxy and clamp it down, and use ptex to fill any gaps in the base. Thoughts?
I’ve seen this type of “crack” get fixed in a shop by taking epoxy and like you said, just put it in there and clamp it tight for a day or two. But make sure to use some marine epoxy that has some flexibility after the cure, especially when talking about the tips which tend to bend/move/flex a lot more than the rest of the ski