Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Full tilt, Liner and custom foot beds
Posts: 317
-
Karma: 72
Ive had my Full tilt booters for about two months now. Ive skied with them a couple of times and only recently i got round to getting the liners heat molded. While i was at the shop i also got new foot beds. Anyone who gets full tilt boots or already has them but hasn't got the liners molded, it makes such a difference so do it as soon as possible!!
Posts: 16177
-
Karma: 4,352
Posts: 59
-
Karma: 13
Ya if you don't get the boots heat molded they are going to really suck. Plus they will be ten times warmer because there is no room for air to get inside them. Also I thought it was pretty obvious that if you don't have your boots heat molded there is no way for them to feel good on your feet.
Posts: 317
-
Karma: 72
Yep that's why I said to do it straight away!!
Posts: 53
-
Karma: 10
ha, it would be the same as wearing a shoe. my boots aren't heat molded and they feel fine, although heat molding would probably feel amazing..you're still dumb.
Posts: 639
-
Karma: 16
if you have intuition liners like the full tilt boots, you would be retarded to ski on them without heat molding.....
the op is right. if your shop lets you walk out of the store with out heat molding intuition liners. i would be looking for a different shop cause they don't know enough to be selling ski equipment.
All times are Eastern (-4)
