Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Smith fuse sensor lense with fog...
Posts: 11149
-
Karma: 1,415
I just opened my new smith fuses w/ sensor lenses from the box and they have a very thin foggish layer in them. I can still see fine, but I worry about what will happen if I ski. Should I give them back to the shop and ask them to swap out lenses or should I use them?
Posts: 11149
-
Karma: 1,415
Posts: 13673
-
Karma: 3,086
Sometimes they include a thin sheet of plastic that stays attached to the lens by static electricity. They put it there to keep it from getting scratched before the goggles are used.
Check the inside and outside of lens to see if that is still on there, because I loved my Fuses until they deserted me in an avie. I think I will hike back up in the summer to find them.
Posts: 11149
-
Karma: 1,415
not there, it is on the replacement lenses though.
Posts: 13673
-
Karma: 3,086
Alrighty.
Try opening the regulator, so that you can see the foam, and leaving them next to the heater/fire overnight. That might work.
Posts: 11149
-
Karma: 1,415
just brought them back from the store.
All times are Eastern (-4)