It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
i'm gonna buy some metal, and get a welder to make a flat bar rail and some kind of kinked rail. what would be a good length for a glat bar rail? what kinda kinked rail would be the funnest to sesh? down-flat-down? flat-down-flat? also, whats the best way to weld supports to these rails?
yeah i had a 16 ft flat bench and i would say thats a nice legnth. if you go shorter than 12 its jsut a waste time/money.
if your going to build a dfd then you will need a hill to put it on. i would say a fdf, like 10 ft sections. then you can practice switchups and spins of all on the same rail (unless you got spins off a down rail good. i personally dont like it much)