Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Lifters on the Look PX 12s
Posts: 1864
-
Karma: 930
I just got some Look PX 12 Ti Lifters because I found a great deal on eBay. I wasn't planning on using the lift plates. When I went to take them off, I noticed that two screws on each heel piece won't come out of the binding. Normally, to mount without the lift, a shop will just use shorter screws. But if they can't get them out is there any way they can cut them down?
'I don't wanna be a pirate!'
Posts: 1864
-
Karma: 930
bump
'I don't wanna be a pirate!'
Posts: 722
-
Karma: 10
yeah just grind down the screws on a belt sander thats what we do at shops when we don't have the screws to the right length so just leave them in and grind em about 1/3 of the way down and youll be allset!
Posts: 1864
-
Karma: 930
Thanks.
'I don't wanna be a pirate!'
All times are Eastern (-4)