Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Replacing Brakes on Tyrolia ff17 bindings
Hey guys. Today I unmounted some tyrolia bindings from my brother's old skis to move to a pair of my extra skis, and I'm in a bit of a pickle.
I forgot to check the width of the brakes, and it turns out the brakes are a bit too narrow to use on my skis. My plan is to bend the brakes into a figure which will fit the skis, so I (forcefully) managed to get the brakes out of these bindings which was much harder than I thought it would be.
The problem is getting them back in. Does anyone know the trick with these Tyrolia bindings and installing brakes into them? On the bindings there are two hooks on the left and right sides which should go above the pin where the spring is curled around.
Without any luck I am not able to get it in, hoping someone happens to know something which will help :/
All times are Eastern (-4)