Welcome to our new beta design! Click here to go back to the old Newschoolers.
SDrvperIf you could plan it out properly it wpuld be sick. The rail/takeoff would be easy to move around, but the start ramp would be harder to make "portable". Where are you trying to store it after each use?
If you are just moving it to the side of ur area u'll be fine, but if you have to put it away in a shed or sometthing each time you might have a hard time building it high enough.
ZacharybActually I have to store it behind a shed which is about 3 or 4 feet wide so I should be fine. now the only thing I need to do is get some money haha
theabortionatorCan you just keep it behind the shed and run it like that? Is there enough of a run out ahead?
If you legit have to break it down your best bet would probably be to have the actual ramp be only 2x4 rails on the side with no supports below. You could fram it plenty strong though. You could get some metal hooks on it and latch it in place against your tower. You could add a little plywood tranny to the bottom of that piece. Then rock your flat bottom and kicker as you already had.
IF you legit have to take it apart and space is limited it will be more compact if the only big thing is the tower and everything else can fit into almost no space.
You could even get super wild and make the tower in sections that can hinge and then get latched in place and latch some supports on.
Idk. In my head building it is totally doable but it would still be a pain in the ass if you just wanna sesh for a little bit. Like setting up the trampoline mat and springs. Its not hard, but it's a pain in the balls if you have to do it every time you want to jump on the tramp.
See if you can make the drop in work from behind the shred, or maybe off the roof so the stuff you have to move is kept to a minimum.
ZacharybAGREED. my plans have changed I am going to keep it behind the shed and move it back as far as possible because the space for rails is limited but I should be getting approximately 4 feet of extra room from moving it back to the fence
theabortionatorHell yeah. That would have absolutely sucked to have to assemble the thing every time you want to shred.