Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Adjusting heel piece on MFD Alltimes?
I got new boots that are a touch smaller than my previous ones so I have to adjust my bindings a bit. Does anyone know if there's any reason why I shouldn't just use a screw driver to take out the screws, move them up a notch to the correct setting, and rescrew them in?
I got them to unscrew by hand so I'm guessing just a really good hand tightening and monitoring their tension periodically should be enough, but I imagine MFD has a specific torque that should applied. Note that they're FKS and can't slide on their heel piece like other bindings (unless I'm wrong on this...).
Thanks for any input!
All times are Eastern (-4)