i know that they make a model for park, the P12 Jib. but i can get a good deal on lifters and was wondering what the difference in the two is? i would also like to know if i would need the wide break version or the normal brake to fit a PE
check back in other posts next time before asking questions like thus, cuz its probably been asked a dozen times. Color and a plastic plate under the binding, are the only difference. Get the cheaper ones, theyre the same. www.absoluteskishop.com
The P12 jib is designed to be mounted flat. Lower center of gravity means they are more stable. The P12ti or lifter has a 27mm lifter plate that is designed be mounted on the ski. For twins lifters are bad. Higher center of gravity leads to less stability, especially if you are a jibber.
^ even more of a dumbass.... get the ones wiht the lifter......and then dont mount them with the lifter on...and guess what...u have the p12 jibs...that is the only difference other than color....soo good job trying to bring someone down u asswhipe
You BOTH are dumbasses. Lifter means nothing you cunts. There is no 28mm lift on them, that is the total HEIGHT of the binding... brillaint. Look at the picture: see the 3 mm plastic pieces? They dont do shit, so leave em on.
^um, you said that the lifters are part the total height of the binding or something... anyways it made no sense and you are a complete dumbass. I am holding in my hands a Look p12 /w lifter and a jib binding. The lifter binding has a small plate called a 'lifter' underneath it that raises the total height of the binding for better carving (HOLY CRAP BATMAN!!! What are the odds of THAT?) Jib binding = no lifter plate. Do a bit of research before you say something stupid (of course, for a simple concept like lifters, you shouldn't even need to)
To answer your second question yes the lifters will fit on PE's they are 80mm, the brakes are 80 mm, perfect fit, trust me I, I have that exact setup.
I smoke chewy like a mothafuckin nut
You got a gram bag hit the zags and roll her up
Cuz a nigga like me can't fake it when I'm high
Get the Visine for the tight red eyes
Jump in the Cutlass with the niggas from the set
The blunt went out but we ain't done yet
Get another one blaze like a barbeque beef
It ain't nothin like a blunt for the funk in ya teeth
Yeah, I'm a skinny 6'5 motherfucker
If you didn't know me you would think I was a clucker
But I'm not a clucker I'm a dodger and a ducker
Come a little closer I'm a show you I'm a punch ya
And if I can't beat you I get my gun and I'm a buck you
Turn you over like a little bitch and I'm a fuck ya
yea dave (wuestinator) your screws will be too long....but if you mount them with the shorter screws then it makes abosolutley no difference.....and to the guy that called me a dumbass, i never tried to explain the use of the lifter....so nice job asshole
considering the base plate that the pivot heel attaches to is part of the heel lifter, its kinda hard to not use it. you can take it off, but the mounting plate is no longer flat, thats why the jib has that neat little orange leveling piece on it!