Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
I just bought a set of 1080 boots and skis with S912Ti bindings from a friend. When I secure (lockdown) the boot into the binding, I can still push down the boot a bit (about 3mm) which gives a 'click' effect everytime I press down the boot. Is this normal for the S912Ti bindings? Or, the bindings are just loose? TIA.
Mine do that too, so i'm guessing it's just the binding/boot configuration.
~I am your master... HeliX~
I have the exact same setup and mine don't do that. Are the bindings set to that size of boot? If not that could be your problem.
Good, so I guess it's normal - I don't need to bring them in for adjustment. I was worried that the skis may pop out in the midst of whatever - it seemed loose - unlike the others I had before. Thanks.
Hmmm... maybe I should take them in for a check up... Strange, supposedly the bindings were adjusted according to the boot size.
I'd get em checked out, the toe piece wings probably need adjustment. I've seen so many of these bindings get wiggly, how old are they?
There ishould be a screw in the top of your toe-piece that you can turn to raise or lower it, just get like a thick piece of construction paper or a business card and put it on the friction plate, when the height is perfect, there should only be a little bit of tension, but you should be able to pull out the card.
He who waits, always wants.
Thank you for your replies. I'll look into it.
All times are Eastern (-4)