first you have to sand down the tops of the skis so the paint can grip something, then paint them (not sure which paint is best. Acrylic?) then you have to buy some off that protectant clear spray and cote the top of your skis with it.
I'm not really an expert and if you feel like searching the articles section there are some detialed articles on how to do it.
Hope that helped
sand the ski down. spray on a grit/primer coat. that makes the next stage stick to the ski better. then u spray the ski with an acryllic, do your design but not more than three layers, the do a double coating of a plastic covering. amek sure it is a little above room temperature when u do it and after all of that run an iron over it to firm up any mistakes.
**Two Tone Productions** __ **Volkl**
Ice, snow, man-made, slush, powder, as long as u land on your feet nothing else matters
FOCUS Premieres in Toronto (Oct 10) and Waterloo (Nov 1) Ontario.
ok first a layer of duct tape, then a layer of saran wrap and make sure u do it a room temperature, then a layer of scotch tape, and then finish it off my dumping gasoline on it, and burn it at room temperature and go ski with it right after that it is sick dude
Anybody need K2 Escape 2500, with look 9 nova bindings message me! comes with free goggles---Best line to a girl whose talkin to u and u don't like her(she should be talking when you say it)wait wait, open your mouth(wait for her to open it)it won't fit(and then walk away)