Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Rail dimensions help
Hey i'm having a rail professionally made by a local skatepark but i'm stuck on what i wanna get. i can't make it too high but i dunno if i can get enough speed. i want somethin where i can trick on and trick off of... i'm thinkin a flat down flat like 6 ft, 10 ft, 6 ft. maybe like 3 ft high at first dropping to 1 ft? (flat bar) maybe i should just get a flat rail to learn the stuf and practice it? but would kinks really make it that much better for like 75 more dollars? the flat down flat would cost like 200 and the flat would be about 125 or so. so any thoughts? height? length? dimensions? kinks?
y dont u just htink about it
Crazy midget productions
double kink sounds good.. but make it higher... make it be like 6-10-6 but starting at 4 or 5 ft. then going to like 2 or 3.. 1 ft is too low
3' high 15' long flat rail if you want to learn on and off, kinks are a little iffy for stuff off unless you have a longer flat at the end so you can get organized out of the last kink
member of the ndsc
with the double kink you could have the hole rail being 3 feet off the ground the hole way so that you have to make base out of dirt to put the rail on
up in arms apperal represent
representin the east
if you get a double kink(flat down flat) keep in mind you can turn in around and tilt it to make a down flat down kink if you want
'Telemarketing looks like it would be hard' -Andy
All times are Eastern (-4)